EUR - DDV vključen
Nastavitev lokacije
Slovenščina
EUR
DDV vključen
Picatinny rail consists of slots with 5.23 mm spaces between one another, which means that it can be used across its entire length. It is simple to mount and interchangeable – if something is made for a Picatinny rail, it will fit regardless of the manufacturer or manufacturing date. It is affordable, resilient and reliable – this is why it so commonly used by professionals and military. Because of all its great qualities, Picatinny rail has been dominating the rail market in the recent years.
Picatinny is a big step forward from the Weaver standard. Weaver has a few predesignated slots while Picatinny has slots all over its surface, allowing the device to be mounted wherever the user finds it fitting. Weaver's slot is 3.8 mm wide, which is why ring mounts made for a Weaver rail will also fit on a Picatinny rail while ring mounts made specifically for a Picatinny rail will not fit on a Weaver rail. This is one of the main reasons why Picatinny is a far better mounting solution.
EAW is a German company, known for producing top-quality mounts. Their Picatinny rails, which are all made from steel, have a nice finish and come with a unique channel in the middle, allowing the user to clearly see the rifle's sights. Screws are included. EAW chooses only the best materials for their products. All of these great features; however, come at quite a steep price.
Carl Gustaf is a Swedish manufacturer of firearms. Their rifles are a continuation of the famous Swedish Husqvarna rifles.
Carl Gustaf 2000's jeweled bolt is finely made and has a short and fast 60° lift. It is equipped with three massive locking lugs which ensure precise lockup. The standard magazine can hold 3 rounds, but there is also a possibility of buying a magazine that can take 4 rounds. There are two holes on each of the mounting surface. Carl Gustaf 2000 rifles can be chambered for the following calibers: .243 Win., 6.5x 55 Swedish, .270 Win., .308 Win., .30-06 Spr., 7x64, 9.3x62, 7mm Rem Mag., and .300 Win Mag.
Carl Gustaf 2000 has a similar action as rifles Carl Gustaf 3000 and Sauer 80/90/92. The radiuses of the mounting surfaces are the same but there is a difference in B distance (see the picture below). This is why two-piece mounts made for Carl Gustaf 2000 will fit rifles Carl Gustaf 3000 and Sauer 80/90/92 while one-piece mounts will not fit them.
Please note that Carl Gustaf 2000 model has one-piece mounts interchangeable with Sauer 80 Magnum and Sauer 90 Magnum models, with the B distance of 107.4 mm.
A: 22 mm
B: 107.4 mm
C: 22 mm
BHU: 0 mm
Fi: 6-48
R1: R16.5
R2: R16.5
Remove all the stains (grease, oil etc.) from the rifle's receiver with a cleaning fluid (acetone). Once the surface is clean and dry, check whether the screws match the rail and the holes on the receiver. Make sure that the Picatinny rail is compatible with the rifle by inspecting the mounting holes on both. Before mounting the rail permanently, apply a minimal amount of thread-locking fluid 278 or 648 on screws and contact surfaces. Be careful not to get the fluid in or near the mounting holes. Carefully clean the remaining excess fluid around the rail with a cleaning fluid. Using a torque driver, screw the screws appropriately (up to 2.2 Nm) – do not overtighten.
The product has a warranty period of 30 years.